Table of Contents
Advertisement
1
Access the tray assembly by following the instructions in
“Removing the Tray Assembly,” earlier in this chapter.
2
Connect the power cable and ribbon cable from the assem-
bly kit to the hard disk connectors.
»
Note: The extra connector on the power cable is for future use and does
not connect to anything at this time.
3
With the controller board ribbon cable and the power cable
fitting under the brackets on the hard disk, attach the other
end of ribbon cable to the controller board connector and
the power cable to the 4-pin controller board connector.
4
Line up the holes on the tray assembly with the holes on the
hard disk bracket flanges.
5
Insert four Phillips screws into the holes and tighten with a
screwdriver.
Hard Disks
Printer Options
6-45
Advertisement
Table of Contents
