Setting Postscript Parameters; Setting Hp Pcl5 Parameters - QMS 1725E Reference

job. This allows the system administrator to select alternate default
emulations.
Menu
Choices
Default
Notes

Setting PostScript Parameters

This menu allows you to select a PostScript emulation level. This is
useful if you have files prepared in an application which is not fully
compatible with Adobe's PostScript Level 2 page description lan-
guage.
Menu
Choices
Default

Setting HP PCL5 Parameters

The QMS Crown Technical Reference (shipped on disk with your
printer) and the HP PCL5 Emulation Technical Reference (available
for purchase from your QMS vendor) contain more detailed informa-
tion on this emulation. In addition, HP PCL5C Technical Support
Notes , available free through the QMS Bulletin Board, Q-FAX, and
Printer Configuration
Administration/Emulations/ESP Default Emul
HPGL, Lineprinter, PostScript, PCL5, CCITT
PCL5
You must turn the printer off and back on again for the change
to take effect. For more information on ESP, see chapter 5,
"Additional Technical Information."
Administration/Emulations/PostScript/Emulation Level
Level 2—For PostScript Level 2 files and most Level 1 files.
Level 1 B/W—For files that contain only black-and-white
PostScript Level 1 operators. This mode does not support the
PostScript color operators; the use of color operators could
cause the print job to fail.
Level 1 Color—For files that contain color PostScript Level 1
operators. This mode accepts color PostScript Level 1
operators and translates these commands to the appropriate
grayscale. This is the recommended setting for Level 1
compatibility since it contains all of the commands in Level 1 B/
W and the color commands.
Level 2
Emulations
4-29