Removing a SIMM
»
Note: SIMM connector 0 (DRAM 0) must always have a SIMM installed.
1
If you have not already done so, access the tray assembly by
following the instructions in Removing the Tray Assembly,
earlier in this chapter.
2
Using the release latch located on each side of the SIMM
connector, release the SIMM.
3
Gently tilt the SIMM forward to a 45° angle. Then slide the
SIMM up and out of the SIMM connector.
4
And then... go to ther previous section, Installing a SIMM.
Intellifont SIMM
Notch
Intellifont SIMM
Printer Options
6-23