Table of Contents
Advertisement
4
Set the PC’s baud rate to 38400 by typing the following:
modex.exe↵
modex # 38400 n 8 ↵
5
Access the Administration/Communication/Serial menu and
set the Hardware Flow Control RTS and CTS values to On,
press the Online/offline or Menu key and select yes to Save
Changes.
6
Access the Administration/Miscellaneous/New Flash Image
menu.
7
Select Yes in the New Flash Image menu.
8
After the updated system software has been written to flash
ROM, the printer returns to
»
Note: The new flash image will not erase the old image until the printer
verifies that the new image is valid.
9
Restart the printer to activate the new system software.
10 Print another advanced status page, and verify that the con-
figuration settings are the same.
L
copy /b *.dl com #
#
Updating System
Software
.
IDLE
Printer Options
YES
6-67
Advertisement
Table of Contents
