Table of Contents
Advertisement
7
Once the metal plate is secure, press the interface board
down to adhere the two plastic feet to the tray assembly.
»
Note: Your optional interface card may look different than the one
shown in the illustration.
8
Open the two ejector latches on the interface board and the
two on the controller board.
»
Note: Your optional interface card may look different than the one
shown in the illustration.
9
Take the plastic ribbon cable and fold it over so that the
notches (keys) face upward on both connectors. Slide the
6-32
Ejector latches
QMS 1725E Print System Reference
Advertisement
Table of Contents
