Adjusting The Sensor With The Setup Support - Siemens SIMATIC Vision Sensor VS 130-2 Manual

4.4

Adjusting the Sensor with the Setup Support

Before you commission the SIMATIC VS 130-2/VS 130-2vcr, you must adjust the
sensor head correctly. using a Web-based setup support. You then see an image
as seen by the sensor head. For more detailed information on the setup support,
refer to the online help.
Step Activity
1
1. Switch on the PC or PG with the Internet Explorer.
2. Turn on the processing unit.
3. Establish the TCP/IP connection between the processing unit and the PC/PG. You can
either do this directly with a crossover cable or by including the processing unit in an existing
network. Both options are described in detail in the online help.
4. Enter the address of the processing unit the Internet Explorer.
Result:
Once the setup support has started, the sensor field of view is displayed on your PC/PG monitor.
The displayed image is updated several times per second.
2 Adjusting the Sensor
1. Bring the code into the image.
2. Set a sharp image by adjusting the distance between the end of the sensor head and the
code correctly.
3. Correct the shutter speed and the brightness if necessary or use one of the automatic
modes (Auto V1 or Auto).
4. Minimize reflected light by viewing the code at a slight angle.
5. Activate the "Triggered only" check box to test the trigger signal and the trigger settings
(trigger source).
6. Tune further settings as required.
Note:
If you have too many errors, clean the lens and diffuser with a lint-free cloth.
3
•
Secure the sensor and then check the correct sensor position.
4
•
Make other parameter settings.
5
•
Check the read result.
6
•
Set the parameters to specify the process interface.
7
•
Train the codes, if already known.
8
•
Change to the processing mode (RUN).
9
Analyze any errors that may occur.
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01
Commissioning
4-5