Instruction: Installation Of Transmitter Sensor - Siemens LDS 6 Operating Instructions Manual

Installation Guidelines
ATEX manual for LDS 6
A5E01206710-02
Installation of Transmitter Sensor
Install the cables, hybrid and loop cable, at the transmitter sensor
according to figure 2.2. Cables are fixed in the sensor with gas-
kets. Always use lubricant on the gaskets before installing, other-
wise these will be very difficult to remove later. Multi-mode fibre
(SMA connector) and the power supply are just connected
straight through to the receiver.
NOTE
Always protect the single-mode fibre (E2000 connector) from dust.
Do not remove the plastic vial until the cable is firmly fastened in
the sensor.
Figure 2.2 Connections in the transmitter sensor
Figure 2.3 Transmitter sensor
9