Operator Input; Overview; Working With The Processing Unit - Siemens SIMATIC Vision Sensor VS 130-2 Manual

5

Operator Input

5.1

Overview

There are two basic ways of controlling the VS 130-2/VS 130-2vcr:
•
Using the Setup Support
•
Using the Processing Unit
With a few exceptions, you can set all the parameters with either method. This is
illustrated based on the example of the "IP Mode" parameter:
•
In the setup support, you will find this parameter in the "Connections" task in
the "Interfaces" tab in the "Ethernet" group in the "IP Mode" drop-down list box.
•
On the processing unit, it is available at the ADJUST menu level (Connect >
Ports > Ethernet > IP Mode).
5.2

Working with the Processing Unit

The display of the processing unit is used to display the currently read code and to
navigate through the menus and make entries.
Example of the display of a code:
C 01 RUN
=SERIES 7
Note
In processing mode, it is not the currently read code that is displayed on the
processing unit when verifying but the string "Verifying=" followed by 4 quality
grades. These belong to the following quality characteristics: 1. Grade belongs to
the quality characteristic symbol contrast, 2. grade belongs to the quality
characteristic print growth, 3. grade belongs to the quality characteristic axial non-
uniformity, 4. grade belongs to the quality characteristic unused error correction.
There are three menu levels:
•
RUN
•
Adjust
•
STOP
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr
A5E00475759-01
√
OK:Menu
5-1