HP 8712ET User Manual page 65

Table 3-1
Frequency 0.300 MHz to
1300 MHz
Range
(HP 8712ET)
Frequency 0.300 MHz to
3000 MHz
Range
(HP 8714ET)
Measurement Transmission
Channel 1
Detection Narrowband
Mode
Measurement B/R
Paths
• Press SRL
structural return loss of a cable. (The
Cable menu.)
• Press Fault Location
the cable fault location. (The
the Cable menu.)
Depending on your selection, the analyzer is set to one of the following
configurations. (The
discussed in the Option 100 User's Guide Supplement.)
Measurement Configurations from the BEGIN Key
Transmission Reflection
0.300 MHz to
1300 MHz
0.300 MHz to
3000 MHz
Reflection
Narrowband
A/R
The following measurement configurations apply to
types in the previous table:
Power Level
Measurement Channel 2
Format
Number of Points
Sweep Time Mode
Sweep Triggering
Averaging
System Bandwidth
1. Factory preset power level is user-defined by using the "Pwr Level at Preset" softkey. The fac-
tory default is 0 dBm.
ET User's Guide
Using the BEGIN Key to Make Measurements
(Option 100 only) if you want to measure the
(Option 100 only) if you want to measure
Fault Location
SRL and Fault Location
Power
10 MHz to
1300 MHz
10 MHz to
3000 MHz
Power
Broadband Internal Broadband Internal
B*
Factory preset power level
Off
Log Mag
201
Auto
Continuous
Off
Medium Wide
Making Measurements
SRL selection is under the
selection is under
configurations are
Conversion Loss
10 MHz to 1300 MHz
10 MHz to 3000 MHz
Conversion Loss
B*/R*
all
of the measurement
1
3-13