HP 8712ET User Manual page 122

NOTE
Figure 4-2
NOTE
Using Instrument Functions
Using Markers
The frequency position of the markers is coupled between the two
measurement channels. Changing the frequency of a marker on one
measurement channel will also change the frequency of the marker on
the other measurement channel.
The examples in this section are shown with a transmission response
measurement of a filter. To follow along with these examples, use the
filter that was shipped with your analyzer, connect the equipment as
shown, and set up the analyzer by pressing the keys shown below the
equipment setup graphic.
Connect the Filter to the Analyzer
Press:
PRESET
Center
FREQ
Span MHz
349
SCALE Autoscale
When you make a hardcopy of your measurement results that contain
displayed markers, you can choose to have a marker table appear on the
hardcopy. Refer to "Printing and Plotting Measurement Results" on
page 4-77.
4-4
MHz
175
ET User's Guide