HP 8712ET User Manual page 380

System BW
Wide
Medium Wide (default)
Medium
Medium Narrow
Narrow
Fine
System Config
System
Controller
SYSTEM
OPTIONS
System Z0
Hardkey/Softkey Reference
S
Dynamic Range
Low
Medium
Medium
Medium
High
High
Softkey in the
SYSTEM OPTIONS
adjust the clock setting, set the beeper volume, adjust the CRT
settings, and configure the rear panel USER TTL IN/OUT port.
Softkey in the HP-IB menu. Makes the network analyzer the system
controller of the HP instrument bus. Required mode for interfacing
with HP-IB peripherals (printers, plotters, and disk drives). Also
required by IBASIC to talk to HP-IB peripherals. This operation mode
is not selectable with another active controller on the bus.
See the Programmer's Guide for more information.
Access Keys:
SYSTEM OPTIONS
Hardkey in the SYSTEM area of front panel.
Softkey in the cal kit menu. Provides access to the system impedance
menu.
Refer to "When to Change the System Impedance" on page 3-8
information.
Access Keys: CAL
8-88
Sweep Speed
Fastest
Faster
Fast
Slow
Slower
Slowest
menu. Displays the menu to
HP-IB
More Cal
Approximate BW
6500 Hz
4000 Hz
3700 Hz
1200 Hz
250 Hz
15 Hz
for more
ET User's Guide