HP 8712ET User Manual page 317

Directory
Utilities
Disp Freq
Resolution
DISPLAY
Display
User List
Distance
Dither
Softkey in the file utilities menu. Displays the menu to change, make,
or remove directories on DOS disks.
See "To Use Directory Utilities" on page 4-65
Access Keys:
SAVE RECALL
Softkey in the
FREQ
resolutions: MHz, kHz, or Hz. For example, a frequency of
1,234,567 Hz can be displayed as: 1 MHz (note rounding down),
1.235 MHz (note rounding up), or 1.234 567 MHz. Default is kHz.
Hardkey in the CONFIGURE area of the front panel. Displays the
menu with selections concerning type of data to be displayed, split or
full screen, title and limit lines.
Softkey in the users setup menu. Displays a table that lists all of the
login user names on the access list of your analyzer.
See The LAN Interface User's Guide Supplement for more information.
Access Keys:
SYSTEM OPTIONS
(Option 100 only) Softkey available under the
add max point and add min point menus. Used to perform fault
location measurements. See your Option 100 User's Guide Supplement
for information.
Softkey in the spur avoid options menu. When selected, shifts spurs
which may be visible in low level measurements.
See "Reducing Trace Noise"
The measurement calibration must be performed with the same spur
avoid option used in the measurement or your results may be invalid.
Access Keys:
MENU
ET User's Guide
File Utilities
menu. Selects one of the displayed frequency
LAN
in Chapter 5 for more information.
Spur Avoid Options
Hardkey/Softkey Reference
for more information.
Login User Setup
MENU key and the
D
8-25