HP 8712ET User Manual page 31

To Configure
Peripheral
Settings
NOTE
NOTE
Analyzer: Press
HP 8712ET Address
The network analyzer's address will appear (the
default is 16). To change the address, press
Enter
If your system uses serial or parallel peripherals, follow the guidelines
below to configure the system. Refer to the peripheral's manual for
correct cables and settings. The parallel and serial ports have standard
Centronics DB-25 and RS232 pinouts respectively as explained in
Chapter 7, "Front/Rear Panel."
Serial
Devices: Press
entry controls to highlight your type of printer or
plotter, and press
handshake at the top of the screen are incorrect, use
the softkeys to change them.
Parallel
Devices: Press
entry controls to highlight your type of printer or
plotter, and press
LAN
Printer: Press
entry controls to highlight HP LaserJet PCL5/6
PCL5 LAN, and press
address at the top of the screen is incorrect, press
LAN Printr IP Addr
When Select Copy Port
the top of the display screen show the current settings.
Use a PCL5 printer for fastest hardcopies. See
Port" on page 4-70 for more information.
ET User's Guide
SYSTEM OPTIONS
or
.
HARDCOPY Select Copy Port
Select . If the baud rate or
Select Copy Port
HARDCOPY
Select .
HARDCOPY Select Copy Port
Select
to enter the correct IP address.
is selected, the first two lines in the box at
Installing the Analyzer
Step 4. Configure the Analyzer
HP-IB ,
HP 8714ET Address
number
. Use the
Use the
.
. Use the
. If the printer IP
"Configure the Hardcopy
.
,
1-15