Logging On And Configuring The Displays - Smart Technologies SMART Room System SRS-LYNC-XS Setup And Maintenance Manual

CHAPTER 4
CONFIGURING YOUR ROOM SYSTEM'S SOFTWARE
5. Select your time zone, specify the current date and time, and then click Next.
IMPORTANT
You must specify the correct date and time. If the room system's date and time are different
than the Lync and Microsoft Exchange servers' dates and times, the room system is unable
to connect to the servers.
The Lync appliance restarts several times. When the basic configuration process is complete,
a screen prompting for the administrator account's password appears.
NOTE
After the Lync appliance shuts down and starts again for the first time, it might prompt you
for a password or it might log in by itself. In either case the Lync appliance will shut down
and start again.
6. Continue to the next procedure.

Logging on and configuring the displays

To log on and configure the displays
1. Type the room system administrator account's password, and then press ENTER.
The SMART end user license agreement appears.
2. Read the SMART end user license agreement, and then click Accept.
The Conferencing Microphone Configuration dialog box appears.
3. Select Use the table microphone, and then click OK.
IMPORTANT
You are unable to change this setting later, so ensure you select the correct option.
The First things first dialog box and a dialog box prompting you to check the display settings
appear.
4. In the First things first dialog box, select Use recommended settings, and then click Accept.
5. In the dialog box prompting you to check the display settings, click OK.
Another dialog box appears, and Control Panel opens.
28 smarttech.com/kb/170450
-