Important Information - Smart Technologies SMART Room System SRS-LYNC-XS Setup And Maintenance Manual

Important information

IMPORTANT
If you were directed to this guide from your room system's quick start guide, proceed to
Configuring your room system's software on page 17.
WARNING
Failure to follow the installation instructions shipped with your SMART product could result in
l
personal injury and product damage which may not be covered by your warranty.
Ensure your installation complies with local building and electrical codes.
l
Do not open or disassemble the SMART product. You risk electrical shock from the high
l
voltage inside the casing. Opening the casing also voids your warranty.
Do not stand (or allow children to stand) on a chair to touch the surface of your SMART
l
product. Rather, mount the product at the appropriate height.
To reduce the risk of fire or electric shock, do not expose your SMART product to rain or
l
moisture.
If your SMART product requires replacement parts, make sure the service technician uses
l
replacement parts specified by SMART Technologies or parts with the same characteristics
as the original.
Ensure that any cables extending across the floor to your SMART product are properly
l
bundled and marked to avoid a trip hazard.
Do not insert objects inside the cabinet ventilation holes, because they could touch
l
dangerous voltage points and cause electric shock, fire or product damage which may not
be covered by your warranty.
Do not place any heavy objects on the power cable. Damage to the cable could cause
l
shock, fire or product damage which may not be covered by your warranty.
Use only extension cords and outlets into which this product's polarized plug can be fully
l
inserted.
Use the power cable provided with this product. If a power cable is not supplied with this
l
product, please contact your supplier. Use only power cables that match the AC voltage of
the power outlet and that comply with your country's safety standards.
i smarttech.com/kb/170450
-