Samsung SF6500 Service Manual page 59

Disassembly and Reassembly
6-41 Feed Roller
1. Before you disassemble the Feed roller, you
should remove :
♦ Side covers (See page 6-10)
♦ Latch clutch (See page 6-13)
♦ Feed clutch (See page 6-14)
2. Pull the bushing shaft slightly upwards and turn
it 45 degrees counterclockwise, so that a hole on
the bushing shaft aligns with the hole on the
main frame.
Bushing Shaft
Figure 6.90
6-30
3. Bushings are attached on both end of the roller.
Push outwards on the bushing shown inside on
the left end of the roller.
Figure 6.91
Note: Check the roller for any stain. If stained,
wipe it off with soft cloth dampened with
water. If the roller is heavily worn, replace
it with a new one.
Feed Roller
Bushing
Samsung Electronics