Samsung SF6500 Service Manual page 48

6-27 Power Inlet
1. Before you disassemble the Power inlet, you
should remove :
♦ Side covers (See page 6-10)
♦ Top cover (See page 6-11)
♦ Rear cover (See page 6-12)
2. Remove the one screw from the SMPS. Unplug
the connector (CON1) from the SMPS board
while you push the lever of the connector.
Figure 6.57
6-28 Mother Board
1. Before you disassemble the Mother board, you
should remove :
♦ Side covers (See page 6-10)
♦ Top cover (See page 6-11)
♦ SMPS (See page 6-18)
2. Unplug all the connectors and remove the two
screws from the Mother board.
Figure 6.59
Samsung Electronics
3. While you holdboth ends of the Power inlet,
CON 1
3. Pull out the board in the arrow direction so that
Disassembly and Reassembly
push it out.
Figure 6.58
the connector (CN8) is unplugged from the
connector on the HVPS board. Then take out the
Mother board.
Figure 6.60
Power Inlet
Mother Board
6-19