Samsung SF6500 Service Manual page 47

Disassembly and Reassembly
6-26 SMPS
1. Before you disassemble the SMPS, you should
remove :
♦ Side covers (See page 6-10)
♦ Top cover (See page 6-11)
2. Remove the screw A securing the main board.
Remove the four screws B securing the ground
wires to the SMPS.
Figure 6.53
3. Remove the two screws securing the SMPS to the
main frame.
Figure 6.54
6-18
B
SMPS
B
A
4. Take out the SMPS and unplug the two
connectors from the SMPS board. You should
unplug the connector (CON1) while you push
the lever of the connector.
Figure 6.55
Note: When you reassemble the SMPS, make sure
that the bottom of the SMPS is fitted into the
groove on the main frame and lower the
SMPS along the groove until the pin
connector on the SMPS board clicks into the
connector on the Mother board.
Figure 6.56
CON 1
Samsung Electronics