Samsung SF6500 Service Manual page 26

Installation
Horizontal Reduction-When you turn on the
automatic reduction feature and an incoming page
contains overflowed data, the machine reduce the
data only in vertical as shown below.
Original
If you want to reduce both in vertical and horizontal
at the same rate in order to maintain height to width
relationships, use the horizontal reduction option. If
you turn on this feature, the machine reduces the
data as shown below.
Original
Press 1 to turn this feature on.
Press 2 to turn this feature off.
Automatic Discard Size-When receiving a
document as long as or longer than a standard letter
size paper installed in your fax machine, you can set
the fax machine to discard any excess image at the
bottom of the page to fit the recording paper size.
If the received page is outside the margin you set, it
will be printed on two sheets of paper at the actual
size.
If the data is within the margin, and the Rx
Reduction feature is turned on, it will be reduced to
fit in the appropriate size paper (Discard does not
take place). If the Rx Reduction feature is turned
OFF or fails, the data within the margin will be
discarded.
Enter the desired discard size using the number
keypad, and press ENTER.
Automatic Redial Term-Your fax machine can
automatically redial a remote fax machine if it was
busy or does not answer the first call.
Enter the number of minutes (from 1 to 7) using the
number keypad.
3-18
Received data
Received data
Automatic Redial Try-Enter the number of
attempts (from 0 to 7) to redial the number before
giving up.
If you enter 0, the machine will not redial.
Ring Before Answer-You can select the number of
times your machine rings before answering an
incoming call. If you are using your machine as both
a telephone and a fax machine, we suggest you set
the ring count to at least 4 to give you time to
answer.
Enter a number from 1 through 7 on the number
keypad.
Smoothing-The smoothing feature enhances the
appearance of incoming faxes by making the lines
smooth and takes no additional time. This function
does not apply to outgoing faxes, or to lists or
reports you print. It is recommended to turn this
feature on for text data, turn it off for picture image.
Press 1 to turn the feature on.
Press 2 to turn the feature off.
Continuous Polling Report-Every time continuous
polling ends, a multi-communication report will be
printed to show the result for each registered station.
Press 1 to print the report automatically each time
continuous polling ends.
Press 2 to turn the feature off. The report will not be
printed.
Forced Memory Transmission-If you are annoyed
that you have to wait until documents in the feeder
are sent out when you try to send or reserve another
fax, turn this feature on. This feature enables all
transmission documents are automatically scanned
into memory before transmission. Memory might be
full.
Press 1 to turn this feature on.
Press 2 to turn this feature off. The LCD display
prompts you to choose either to scan the documents
into memory or not before dialing the number when
you try to send or reserve a fax.
Samsung Electronics