Samsung SF6500 Service Manual page 49

Disassembly and Reassembly
6-29 Fuser
1. Before you disassemble the Fuser, you should
remove :
♦ Side covers (See page 6-10)
♦ Top cover (See page 6-11)
2. Unplug the three connectors (H4, H5, H7) from
the HVPS board. Release the connector wires by
removing the cover switch that ties the wires in a
bundle.
Figure 6.61
6-20
3. Remove the one screw securing the ground wire
to the SMPS and unplug the connector from the
SMPS board.
Then remove the four screws securing the Fuser
to the main frame and take out the Fuser.
Note: When you reassemble the Fuser, if it is
Cover switch
Fuser
Figure 6.62
difficult to plug the connector to the SMPS
board, take out the SMPS by removing the
two screws securing the SMPS, then plug the
connector to the SMPS board.
Samsung Electronics