Samsung SF6500 Service Manual page 42

6-17 Solenoid
1. Before you disassemble the Speaker, you should
remove :
♦ Left side cover (See page 6-10)
2. Remove the two screws securing the Solenoid to
the main frame and unplug the connector from
the Mech board. Then take out the Solenoid.
6-18 Latch Clutch
1. Before you disassemble the Latch clutch, you
should remove :
♦ Left side cover (See page 6-10)
2. Remove the one screw securing the clutch and
take out the clutch and its spring.
Spring
Latch Clutch
Figure 6.37
Samsung Electronics
Figure 6.36
Note: When you reassemble the Latch clutch, you
should set the spring into the clutch as shown
below; then replace the clutch.
Figure 6.38
Disassembly and Reassembly
Solenoid
A
B
6-13