Siemens SIPROTEC 4 7UT6 Series Manual page 332

Mounting and Commissioning
3.1 Mounting and Connections
Input/Output Board C-I/O-9 (all versions 7UT613/63x)
The input/output board C-I/O-9 is used in the versions 7UT613, 7UT633 and 7UT635. Mounting location: for
7UT613 slot 33, for 7UT633 and 7UT635 slot 33 right side
[ein-ausgabebgr-c-io-9-einbauplatz-33-040403-st, 1, en_GB]
Figure 3-12
Jumpers X71 through X73 serve for module identification and must not be changed. The following table
shows the preset jumper positions.
Table 3-19
Jumper 7UT613
Platz 33
X71 2-3 (L)
X72 1-2 (H)
X73 2-3 (L)
332
Input/output boards with representation of the jumpers required for checking the settings
Jumper settings of the Module addresses of input/output boards C-I/O-9; slot 33 in 7UT613 or
slot 33 right in 7UT633 and 7UT635
7UT633 and 7UT635
Slot 33 right
2-3 (L)
1-2 (H)
2-3 (L)
SIPROTEC 4, 7UT6x, Manual
C53000-G1176-C230-5, Edition 09.2016