ABB IRC5 Product Manual page 209

Refitting
The procedure below details how to refit the Flange disconnect unit.
3HAC021313-001 Revision: K
Action
4. Loosen the two upper attachment screws and
remove the unit.
5. Disconnect the cables.
Action
1.
DANGER!
Before any work inside the cabinet, please observe
the safety information in section
sure that the main power has been switched off! on
page 28.
2. Reconnect the cables.
3. Refit the unit and fasten the two upper attachment
screws.
4. Refit the two lower attachment screws.
5. Refit the link to the unit.
4 Repair activities, controller IRC5
4.4. Replacement of Flange disconnect
Note/Illustration
xx0600003140
• A: attachment screws
Note/Illustration
DANGER - Make
Continued
207