ABB IRC5 Product Manual page 194

4 Repair activities, controller IRC5
4.3.2. Replacement of power distribution board
Continued
Refitting
The procedure below details how to refit the power distribution board.
192
Action
1.
DANGER!
Before any work inside the cabinet, please
observe the safety information in section
DANGER - Make sure that the main power
has been switched off! on page
2. Refit the new power distribution board by
pushing it leftward to fit the left screw
head.
Refit the right screw.
3. Lock the unit in place by tighten the
attachment screws.
4. Reconnect the connectors X1 - X9.
CAUTION!
Hot surface on top of the power distribu-
tion board unit.
Do not route or place cables on top of the
power distribution board.
Note/Illustration
28.
xx070000122
• A: left attachment screw
• B: right attachment screw
3HAC021313-001 Revision: K