NETGEAR GS752TP Software Administration Manual page 265

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
You can configure more settings to control access to the network through the ports. See
Port Security Interface Configuration
4. Click APPLY.
5. In the 802.1x Configuration screen, set the port-based authentication state and guest VLAN
mode to Enable and click APPLY.
For more information, see
This example uses the default values for the port authentication settings, but you can
configure several more settings. For example, the EAPOL Flood Mode field allows you to
enable the forwarding of EAPoL frames when 802.1x is disabled on the device.
6. In the RADIUS Server Configuration screen, configure a RADIUS server with the following
settings:
• Server Address. 192.168.10.23
• Secret Configured. Yes
• Secret. secret123
• Active. Primary
For more information, see
7. Click Add.
8. In the Authentication List screen, configure the default list to use RADIUS as the first
authentication method.
For more information, see
This example enables 802.1x-based port security on the switch and prompts the hosts
connected on ports g1–g8 for an 802.1x-based authentication. The switch passes the
authentication information to the configured RADIUS server.
on page 184 for information about the settings.
Port Security Interface Configuration
Configure RADIUS Settings
Authentication List Configuration
Configuration Examples
265
on page 184.
on page 160.
on page 166.