NETGEAR GS752TP Software Administration Manual page 121

• Forbidden. Specifies that this interface is forbidden from joining this group on this
VLAN.
• Excluded. Indicates that the interface is not currently a member of this multicast
group on this VLAN.
Note: If an interface was added to the Multicast group as a result of
IGMP/MLD snooping, its status is Dynamic. This status cannot be
selected manually.
5. Click APPLY to send the updated configuration to the switch.
Multicast Forward All
The Multicast Forward All screen contains fields for attaching ports or LAGs to a device that
is attached to a neighboring multicast router or switch. Once IGMP snooping is enabled,
multicast packets are forwarded only to the appropriate port or VLAN.
To configure the Multicast Forward All feature:

1. Select Switching
The following screen displays:
2. Select the VLAN ID for which you want to configure multicast forward all settings.
• To configure the multicast group for a physical port, click PORTS.
• To configure the multicast group for a link aggregation group (LAG), click LAGS.
• To configure the multicast group for both physical ports and LAGs, click All.
3. Select the check box next to the interfaces to configure.
You can select multiple interfaces to apply the same setting to the selected interfaces.
Select the check box in the heading row to apply the same settings to all interfaces.
4. Select the status of the interfaces. The possible values are:
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Multicast Static Multicast Address
 
Configuring Switching Information
Multicast Forward All.

121