NETGEAR GS752TP Software Administration Manual page 154

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The Policy Attribute section of the screen displays.
2. Configure the policy attributes by selecting the check box associated with the attribute to be
configured and then entering the required data:
• Assign Queue. Select the destination queue. There are four queues with valid values
from 0 to 3 (3 is the highest).
• Drop. Select this option to drop packets for this policy-class.
• Mark VLAN CoS. Select the specified Class of Service queue number to mark all
packets for the associated traffic stream with the specified Class of Service value in
the priority field of the 802.1p header. If the packet does not already contain this
header, one is inserted.
• Mark IP DSCP. Select an IP DSCP value. All packets for the associated traffic stream
are marked with this value. If you select Other, enter a custom value in the DSCP
Value field that appears.
• Simple Policy. Exists in switch mode only. Select this radio button to establish the
traffic policing style for the specified class. The simple form of the policy command
uses a single data rate and burst size, resulting in two outcomes: confirm and violate.
3. If you select the Simple Policy radio button, you can configure the following fields:
• Color Mode. Color aware mode requires the existence of one or more color classes
that are valid for use with this policy instance; otherwise, the color mode is color blind,
which is the default.
Configure Quality of Service
154