NETGEAR GS752TP Software Administration Manual page 189

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The following screen displays:
2. From the ACL Type list, select the ACL type used to create the ACL.
You can select from 10optional types:
• ACL Based on Destination MAC. Creates an ACL based on the destination MAC
address, destination MAC mask, and VLAN.
• ACL Based on Source MAC. Creates an ACL based on the source MAC address,
source MAC mask, and VLAN.
• ACL Based on Destination IPv4. Creates an ACL based on the destination IPv4
address and IPv4 address mask.
• ACL Based on Source IPv4. Creates an ACL based on the source IPv4 address and
IPv4 address mask.
• ACL Based on Destination IPv6. Creates an ACL based on the destination IPv6
prefix and IPv6 prefix length.
• ACL Based on Source IPv6. Creates an ACL based on the source IPv6 prefix and
IPv6 prefix length.
• ACL Based on Destination IPv4 L4 Port. Creates an ACL based on the destination
IPv4 layer 4 port number.
• ACL Based on Source IPv4 L4 Port. Creates an ACL based on the source IPv4
layer 4 port number.
• ACL Based on Destination IPv6 L4 Port. Creates an ACL based on the destination
IPv6 layer 4 port number.
• ACL Based on Source IPv6 L4 Port. Creates an ACL based on the source IPv6
layer 4 port number.
3. Configure the settings in the following table, based on the selection in the ACL Type list:
Managing Device Security
189