Static Multicast Address - NETGEAR GS752TP Software Administration Manual

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Multicast Router VLAN Configuration
The statically configured router attached (VLAN, interface) is added to the learned multicast
router attached interface list if the interface is active and is a member of the VLAN. As is not
the case in the previous release of the system firmware, snooping dynamic learning mode
(snooping interface mode or snooping VLAN mode) does not need not to be enabled on the
interface. The dynamic learning mode is applicable only for dynamically learned multicast
router information (queries from an attached true querier).
To configure the Multicast Router VLAN:

1. Select Switching
The following screen displays:
2. In the Interface field, select the interface ID.
The entry corresponding to the specified interface is selected.
3. In the VLAN ID field, enter the VLAN ID for which the multicast router mode is to be enabled
or disabled.
4. In the Multicast Router field, enable or disable multicast router on the selected interface.
5. Click APPLY to send the updated configuration to the switch.
Configuration changes take place immediately.

Static Multicast Address

The Static Multicast Address link feature contains features described in the following
sections:
Multicast MLD Snooping
 
Configuring Switching Information
118
Multicast Router VLAN Configuration.
