NETGEAR GS752TP Software Administration Manual page 175

The following screen displays:
2. In the Rule Type field, select Permit or Deny as the action to be performed when the rule
is matched.
3. In the Service Type field, select HTTP, Secure HTTP (SSL), or SNMP.
The access rule is restricted according to the service type.
4. In the Source IP Address field, enter the IP address from which traffic is originated.
5. In the Mask field, enter the IP mask of the source IP addresses.
6. In the Priority field, enter a priority for the rule.
The rules are validated against an incoming management request in the ascending order
of their priorities. When a rule match is detected, the rule action is performed and
subsequent rules are ignored. For example, if a source IP 10.10.10.10 is configured with
priority 1 to permit, and source IP 10.10.10.10 is configured with priority 2 to deny, then
access is permitted if the profile is active, and the second rule is ignored.
7. Click ADD. Make sure that the access profile is created before adding the rules.
To configure a security access rule:

1. Select the checkbox next to the security access rule to be modified.
2. Update the relevant fields.
3. Click APPLY to update the switch with the new settings.
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
Managing Device Security
175