NETGEAR GS752TP Software Administration Manual page 129

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switches
The following screen displays:
2. In the VLAN ID field specify a VLAN ID.
This VLAN identifier (VID) associated with this VLAN is created if it does not exist. The
valid range is 1–4093.
3. In the IP Address field, specify the IP address of the VLAN interface.
4. In the Network Mask field, specify the subnet mask of the VLAN interface.
5. Select the operation mode for ports and LAGs.
The Port and LAG fields each display selectable physical ports and LAGs (if any).
Selected interfaces are added to the routing VLAN. Each interface can be configured to
operate in one of three modes:
• T(Tagged). Select the interfaces on which all frames transmitted for this VLAN are
tagged. The interfaces that are selected are included in the VLAN.
• U(Untagged). Select the interfaces on which all frames transmitted for this VLAN are
untagged. The interfaces that are selected are included in the VLAN.
• BLANK(Autodetect). Select the interfaces that might be dynamically registered in
this VLAN using GVRP. This selection has the effect of excluding an interface from
the selected VLAN.
6. Click APPLY to send the updated configuration to the switch.
Configuration changes take place immediately.
Configuring Routing
129