Information On Electromagnetic Compatibility (Emc) - Siemens SINAMICS S110 Manual

Danger of injury caused by foreign objects in the device
Parts (e.g. drilling chips, end sleeves) falling into the device can cause short-circuits and
damage the insulation. This can lead to serious injuries (arcing, bang, pieces flying out of
the equipment).
• Only perform installation and other work when the devices are current-free.
• Cover the ventilation slits during the installation of the cabinet and remove the cover
NOTICE
Damage due to use of incorrect coupling or cabinet bushings on DRIVE-CLiQ connections
Damage or malfunctions can occur on the devices or system if incorrect or unreleased
couplings or cabinet bushings on DRIVE-CLiQ connections are used.
• Only use the DRIVE-CLiQ couplings and DRIVE-CLiQ cabinet bushings described in
10.3

Information on electromagnetic compatibility (EMC)

Requirements to implement EMC are listed in EN 61000-6-2, EN 61000-6-4, EN 61800-3,
EN 60204-1 and in the "EMC installation guideline" Configuration Manual (Article No.
6FC5297-0AD30-0xPx). Conformance with the EMC Directive of the EC can be ensured by
following the measures described in the "EMC installation guideline" Configuration Manual.
When mounting components in cabinets, in order to fulfill the EMC Directive, the following
conditions must be additionally observed:
● Connected to TN or TT line supply systems with grounded neutral point
● SINAMICS line filter
● Observance of information about cable shielding and equipotential bonding
● Only the recommended Siemens power and signal cables are used
● Only cables from Siemens may be used for DRIVE-CLiQ connections
You will find MOTION-CONNECT cables in catalog PM21.
SINAMICS S110
Manual, 07/2015, 6SL3097-4AC10-0BP5
WARNING
before switching on.
Chapter Accessories (Page 213).
Cabinet design and EMC for components, Blocksize format
10.3 Information on electromagnetic compatibility (EMC)
229