Behavior Of The Leds In The Operating State - Siemens SINAMICS S110 Manual

RDY
Red 0.5 Hz
Red 2 Hz
Red 2 Hz
7.5.2

Behavior of the LEDs in the operating state

Table 7- 25 Control Unit CU305 - description of the LEDs in the operating state
LED Color
RDY -
(READY)
Green
Red
Red/green
Orange
Green/
Orange
or
Red/
Orange
SINAMICS S110
Manual, 07/2015, 6SL3097-4AC10-0BP5
LED
COM OUT>5V
Red 0.5 Hz OFF
Red OFF
Red 2 Hz OFF
Status Description/cause
Off Electronics power supply is missing or outside
permissible tolerance range.
Continuous light The unit is ready for operation.
Cyclic DRIVE-CLiQ communication is in pro-
gress.
Flashing light Commissioning/reset
0.5 Hz
Flashing light 2 Writing to the memory card.
Hz
2 Hz General errors
flashing light
0.5 Hz The Control Unit is ready for operation, but there
flashing light are no software licenses.
0.5 Hz Updating the firmware of the DRIVE-CLiQ com-
flashing light ponents.
2 Hz DRIVE-CLiQ component firmware update com-
flashing light pleted. Waiting for POWER ON of the corre-
sponding component.
2 Hz Recognition of components via LED is activat-
flashing light ed
Note:
Both options depend on the LED status when
activated.
Status
MOD
OFF Firmware update
complete, waiting for
POWER ON
OFF Firmware check
(CRC error)
OFF Firmware or memory
card incompatible
.
1)
CU305 Control Units
7.5 Meaning of LEDs
Comment
-
CRC is incorrect.
Check the firmware version or
memory card.
Remedy
Check the power sup-
ply
-
-
-
Check parameter
assign-
ment/configuration.
Install the missing
licenses.
-
Switch on the compo-
nent.
-
159