Spare Parts; Recycling And Disposal - Siemens SINAMICS S110 Manual

Procedure
● Make sure that the device does not receive a power-on command (e.g. from the keyboard
or terminal block).
● Connect the forming circuit.
● While forming, the incandescent lamps must become less bright or go completely dark. If
the incandescent lamps continue to be brightly lit, a fault has occurred in the drive unit or
in the wiring.
● To form using resistors, the modules must remain in the circuit for approx. 1 h. The
resistors will become very hot if there is a fault in the unit (surface temperature > 80 °C).
11.4

Spare parts

Spare parts are available on the Internet at:
http://support.automation.siemens.com/WW/view/de/16612315
11.5

Recycling and disposal

Dispose of the product according to the applicable national regulations.
The products described in this Equipment Manual are extensively recyclable on account of
the low-toxic composition of the materials used. To recycle and dispose of your old device in
an environmentally friendly way, please contact a company that disposes of electronic
waste.
SINAMICS S110
Manual, 07/2015, 6SL3097-4AC10-0BP5
Service and maintenance
11.4 Spare parts
251