Alcatel-Lucent 7710 SR Configuration Manual page 336

Service router os basic system
Hide thumbs Also See for 7710 SR:
Table of Contents

Advertisement

System Command Reference
now — Forces a reboot of the router immediately without an interactive confirmation.
save
Syntax
save [file-url] [detail] [index]
Context
admin
Description
This command saves the running configuration to a configuration file. For example:
A:ALA-1>admin# save ftp://test:test@192.168.x.xx/./100.cfg
Saving configuration .........Completed.
By default, the running configuration is saved to the primary configuration file.
Parameters
file-url — The file URL location to save the configuration file.
detail — Saves both default and non-default configuration parameters.
index — Forces a save of the persistent index file regardless of the persistent status in the BOF file.
Page 336
Any of the above conditions may render cards inoperable requiring a return of the card for
resolution.
The time required to upgrade the firmware on the cards in the chassis depends on the number of
cards to be upgraded. On system reboot, the firmware upgrades can take from approximately 3
minutes for a minimally loaded 7710 SR to 8 minutes for a fully loaded 7710 SR chassis after
which the configuration file will be loaded. The progress of the firmware upgrades can be
monitored at the console. Inserting a single card requiring a firmware upgrade in a running
system generally takes less than 2 minutes before the card becomes operationally up.
Default
The primary configuration file location.
Values
file url:
local-url:
remote-url:
cflash-id:
Default
Saves non-default configuration parameters.
The index option can also be used to avoid an additional boot required while changing your
system to use the persistence indices.
7710 SR OS Basic System Configuration Guide
local-url | remote-url: 255 chars max
[cflash-id/][file-path]
[{ftp://} login:pswd@remote-locn/][file-path]
remote-locn [ hostname | ipv4-address | "["ipv6- address"]" ]
ipv4-address
a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x - [0..FFFF]H
d - [0..255]D
interface - 32 chars max, for link local addresses
cf1:, cf1-A:, cf1-B:, cf2:, cf2-A:, cf2-B:, cf3:, cf3-A:, cf3-B:

Advertisement

Table of Contents
loading

Table of Contents