Table of Contents
Advertisement
System Command Reference
loopback-period
Syntax
loopback-period period
no loopback-period
Context
config>system>atm>oam
Description
This command specifies the number of seconds between periodic loopback attempts on an ATM
endpoint that has periodic loopback enabled.
Parameters
period — Specify the time, in seconds, between periodic loopback attempts.
retry-down
Syntax
retry-down retries
no retry-down
Context
config>system>atm>oam
Description
Specifies the number of OAM loopback attempts that must fail after the periodic attempt before the
endpoint will transition to AIS-LOC state.
The retry values are configured on a system wide basis and are affective on the next period cycle of
any ATM VC SAP using periodic-loopback, if changed. The timeout for receiving a loopback
response from the remote peer and declaring the loopack failed is 1 second and is not configurable.
Parameters
retries — Specify the number of failed loopback attempts before an ATM VC goes down.
retry-up
Syntax
retry-up retries
no retry-up
Context
config>system>atm>oam
Description
This command specifies the number of consecutive OAM loopback attempts that must succeed after
the periodic attempt before the endpoint will transition the state to up.
Parameters
retries — Specify the number of successful loopback replies before an ATM VC goes up.
Page 280
Values
1 — 40
Default
10
Values
0 — 10 (A zero value means that the endpoint will transition to AIS-LOC state
immediately if the periodic loopback attempt fails.)
Default
4
7710 SR OS Basic System Configuration Guide
Advertisement
Table of Contents
