Sagem -LINK F Installation And Operation Manual page 87

SAGEM-LINK F
Installation and Operation Manual
3.3.6.3 - Modem Configuration Menu
If a modem is to be connected on the MGMT1 port, click on the Modem Configuration /local or remote
menu.
The following screen appears :
Select the tab corresponding to your modem.
Initialization sequence : ATE0 to remove modem echo, then ATQ1 for the modem response codes,
then the command line.
Dialing prefix A : enter phone number used for calling
Dialing prefix B : enter other phone number is case of unavailability of "A"
Retries : Number of failed call attempts
Timeout : Line disconnection time in minutes (when no call message is detected)
Note : Before dialing the NMI can send an AT command in order to block automatic disconnection in
case of inactivity. This command may be different according to the modem type.
ATS34=0 for a SAGEM modem
ATS19=0 for a US Robotics modem
No command for the other modems. In this case the initialization sequence must be customized in
order to :
Deactivate automatic disconnection in case of inactivity
-
Save the configuration
-
Reproduction and communication prohibited without the written permission of Sagem Communication
288055571-04
Page 87/142
Issue 04 : July 2005