Sagem -LINK F Installation And Operation Manual page 61

SAGEM-LINK F
Installation and Operation Manual
Click on the Yes button to activate the relays, or on the No button to disable the relays. In this case,
alarm relays color in main Pilot screen become blue.
3.2.4.6 - Configuring the Auxiliary Channels AUX1, AUX2 and AUX3.
On the main Pilot screen go to the menu Tools / Config Tools / Equipment Settings/ Local.
Note : Connector pinout could vary depending on the selected option (refer to chapter1 description).
3.2.4.7 - Configuring the Automatic Transmit Power Control (ATPC).
ATPC is a process which is used to limit transmit power to the minimum necessary while having a
good transmission. When ATPC is selected for equipments in a network working in the same
frequency band, it allows to increase density and frequency re-use.
ATPC must not be active during antenna alignment process.
ATPC settings depend on the structure of the network (frequency re-use, interferers, link margin).
The operator has to define three main parameters :
•
Maximum ATPC transmit power
•
Minimum ATPC transmit power
•
ATPC receiver threshold
Minimum and maximum ATPC transmit powers must be within transmitter power range, and
Maximum ATPC Transmit power – Minimum ATPC Transmit Power ≤ 20 dB.
ATPC threshold must be within –50 dBm to –80 dBm range.
The ATPC process consists of reducing transmit power as low as possible within the specified
range, without having errors on the remote end, and without having a remote receive level lower
than the ATPC threshold.
To activate ATPC click on the ATPC button on main Pilot screen. The ATPC button indication is
"ON" when ATPC works, or "OFF" when ATPC is disabled.
To configure ATPC, use the menu Tools/Config Tools/ATPC/ Local (or Remote)
Reproduction and communication prohibited without the written permission of Sagem Communication
Select V11 or V28
Interface
288055571-04
Select AUX 3
Interface
Page 61/142
Issue 04 : July 2005