Sagem -LINK F Installation And Operation Manual page 19

SAGEM-LINK F
Installation and Operation Manual
Plug DC connector into IDU connector. If the terminal is a 1+0 system, switch on the terminal
with the switch in front panel. If the terminal is a 1+1 system, switch on both switches.
The green LED(s) labeled "Power" should be lit.
Connect a PC on IDU front panel DB9 connector Labeled "PC" and run the Sagem Link F Pilot
software
Verify and change if necessary, terminal local parameters (refer to Sagem Link Pilot
description in chapter 4) :
- Transmit frequency,
- capacity,
- modulation,
- transmit power
- Link ID Code
- ATPC must be in the "Off" position at that time
Unless the link is already operating (remote parameters are displayed on the right side of the
main screen of the Pilot software), make sure local terminal parameters are in accordance
with far end terminal parameters. (Frequency, capacity, modulation, and Link ID Code must
match)
If remote terminal parameters are good and if the main screen displays a "No Remote Radio"
message, it means antennas are not properly aligned.
Reproduction and communication prohibited without the written permission of Sagem Communication
288055571-04
Page 19/142
Issue 04 : July 2005