Sagem Link F Pilot : Main Operations To Configure A Link; Installing The Sagem-Link F Pilot Software; Connecting The Laptop To Sagem-Link F Idu - Sagem -LINK F Installation And Operation Manual

SAGEM-LINK F
Installation and Operation Manual

3.2 - SAGEM LINK F Pilot : Main Operations to Configure a Link

This section describes all operations to configure main parameters of Sagem Link F radios. Main topics
covered are :
•

Installing the SAGEM-LINK F Pilot Software

•

Connecting the laptop to SAGEM-LINK F IDU

•
Link Preliminary configuration
• Completing Link Configuration
3.2.1 - Installing the SAGEM – LINK F Pilot Software
Insert SAGEM LINK F CD-ROM into the drive. SLF Pilot software is launched automatically, if the CD-
ROM drive has been configured with the "Autorun" option.
If the program does not start automatically, use Windows Explorer and run the "setup.exe" file.
Installation is automatic, and does not require any manual configuration. SLF Pilot can be run by
double clicking on the shortcut.
Note : if the computer has no serial port available, it is necessary to use an USB-serial port adapter.
SAGEM LINK F Pilot application requires a COM port between 1 and 4. If you use a different COM
port, SAGEM LINK F equipment will not be recognized by the SLF Pilot.
In order to check what COM port has been affected by Windows after adapter installation, go to the
Control Panel / System / Hardware / Device Manager/Ports (COM & LPT) and click on the COM and
LPT icon.
Click with the right button on the icon corresponding to your USB – serial adapter, and select
"Properties". Then select the tab "Port Settings" and click on the button "Advanced".
On this screen you can see what COM port is currently used for the adapter.
If the adapter has been affected on a COM port which is not comprised between COM1 and COM4,
then change the COM port number to a number between 1 and 4. If there is not an available COM port
in this range, it should be necessary to disable one existing port and to affect it for the adapter.
3.2.2 - Connecting the Laptop to SAGEM – LINK F IDU
Connect the laptop to the "PC" port of a SAGEM LINK F IDU using a serial RS232 cable.
Reproduction and communication prohibited without the written permission of Sagem Communication
Serial Cable
Ref : 55 670 223 (1.5 m)
55 670 224 (3 m)
PC Call Mgr 100b
Main
IDU
TRIB 1-4 TRIB 5-8
Trib
Cust
POW
EO West East TRIB 9- TRIB 13-
288055571-04
S OD
On
Off
POW
Page 49/142
Issue 04 : July 2005