Link Preliminary Configuration - Sagem -LINK F Installation And Operation Manual

SAGEM-LINK F
Installation and Operation Manual
The IDU is connected to its ODU, and to a DC power supply. Switch on the IDU with the switch in front
panel and run the SAGEM LINK F Pilot software.
The following screen appears :
An IDU has been detected in COM1
When an IDU is detected, then the port, the IDU type, the software version and the serial numbers are
indicated on the first screen. In order to access to SLF Pilot main screen, click on the OK button.
If the following screen appears without any indication, then it means the equipment is not properly
connected, or not powered, or PC COM port is not properly configured.
No equipment detected
Click on the Rescan
button
Check if IDU is powered, if PC cable and COM settings are good, and click on the "Rescan" button.

3.2.3 - Link Preliminary Configuration

Reproduction and communication prohibited without the written permission of Sagem Communication
Click on the OK button
288055571-04
Page 50/142
Issue 04 : July 2005