Sagem -LINK F Installation And Operation Manual page 117

SAGEM-LINK F
Installation and Operation Manual
Ethernet bridge or to combine both E1 and Ethernet. In this case, the useful bandwidth for Ethernet is
reduced.
To configure Ethernet capacity, run the Pilot software in super user mode.
The following screen appears :
Ethernet Capacity
and E1 selection
Two buttons are used to configure Ethernet and E1 capacities :
The left button
additional E1 involved, and the current Ethernet bandwidth.
Current radio channel Bandwidth = 14 MHz
Other possible values 3.5M (3.5 MHz)
Note : for the highest data rate, an additional E1 is always available (Trib #9), and is not configurable.
This E1 does not appear on the Pilot capacity selection screen.
Reproduction and communication prohibited without the written permission of Sagem Communication
Modulation Scheme
Selection
Ethernet and Tributary input alarms
indicates current radio channel bandwidth, the number of
14M/9xE1+Eth(17M)
7M (7 MHz)
28M (28 MHz)
9 E1 tributaries installed
Other possible values
0xE1, 1xE1, 2xE1, 3xE1,
4xE1, 5xE1, 7xE1
Use Tools / Ethernet Configuration
menu to configure Ethernet
parameters
Current Ethernet Bandwidth = 17 MHz
Other possible values : refer to Table 6.1
288055571-04
Page 117/142
Issue 04 : July 2005