SAGEM-LINK F
Installation and Operation Manual
3.1 - Overview
This chapter describes Sagem Link F Pilot software which is the Graphical User Interface used to
control all SAGEM LINK F operations. It provides information on using, starting and exiting the SLF
Pilot and on understanding all features.
First, all necessary operations to start and to configure a link are presented. In a second part of this
chapter all menus are described.
The SLF Pilot allows the user to :
•
View local and remote terminal configuration
•
Set and change parameters on local and remote terminals
•
Monitor RSL, BER and alarms
•
Download and activate a new firmware version
•
Perform specific installation and maintenance operations
•
Set network management configuration
Software environment
The SLF Pilot is run on a PC with the following minimum configuration :
•
Operating System : Windows 2000 or Windows XP
•
Pentium 4 or above, 1 GHz minimum
•
Memory 256 Mbytes of RAM
•
50 Mbytes available on hard disk
•
CD ROM drive
•
One serial port COM1 to COM4 (or USB port + serial to USB adapter)
•
A SVGA Screen, with 600 x 800 minimum resolution (16 colors minimum)
Note :
This chapter describes mainly SAGEM-LINK F Pilot software with nx2 Mbit/s IDUs.
is installed, some screen may differ slightly. Refer to description in Chapter 6 for Ethernet version.
Reproduction and communication prohibited without the written permission of Sagem Communication
Sagem Link F Pilot Description
288055571-04
Chapter 3
If Ethernet option
Page 48/142
Issue 04 : July 2005