Displaying And Maintaining Pbr; Pbr Configuration Examples; Packet Type-Based Local Pbr Configuration Example - HP FlexFabric 12900E Series Configuration Manual

Step
2. Create a VXLAN tunnel
interface and enter tunnel
interface view.
3. Specify
outbound PBR.

Displaying and maintaining PBR

Execute display commands in any view and reset commands in user view.
Task
Display PBR policy information.
(In standalone mode.) Display the PBR
configuration and statistics for a VLAN
interface.
(In IRF mode.) Display the PBR configuration
and statistics for a VLAN interface.
Display PBR configuration.
(In standalone mode.) Display the outbound
PBR configuration and statistics for a VXLAN
tunnel interface.
(In IRF mode.) Display the outbound PBR
configuration and statistics for a VXLAN tunnel
interface.
(In standalone mode.) Display local PBR
configuration and statistics.
(In IRF
configuration and statistics.
(In standalone mode.) Display interface PBR
configuration and statistics.
(In IRF mode.)
configuration and statistics.
Clear PBR statistics.

PBR configuration examples

Packet type-based local PBR configuration example

Network requirements
As shown in
Command
interface tunnel tunnel-number
mode vxlan
a policy for
ip
policy-name egress
mode.) Display local
Display interface
Figure 84, Switch B and Switch C cannot reach each other.
policy-based-route
Command
display ip policy-based-route [ policy policy-name ]
display ip policy-based-route apply vlan-interface
interface-number [ slot slot-number ]
display ip policy-based-route apply vlan-interface
interface-number
slot-number ]
display ip policy-based-route setup
display ip policy-based-route
interface-type interface-number [ slot slot-number ]
display ip policy-based-route
interface-type interface-number [ chassis chassis-number
slot slot-number ]
display ip policy-based-route local [ slot slot-number ]
display ip policy-based-route
PBR
chassis-number slot slot-number ]
display ip policy-based-route interface interface-type
interface-number [ slot slot-number ]
display ip policy-based-route interface interface-type
PBR
interface-number
slot-number ]
reset ip policy-based-route
policy-name ]
363
Remarks
By default, no tunnel interfaces
exist.
The endpoints of a tunnel must
use the same tunnel mode to
correctly transmit packets.
By default, no policy is specified
for outbound PBR on a VXLAN
tunnel interface.
chassis
[ chassis-number
egress
egress
local
[ chassis chassis-number
statistics
slot
interface
interface
[ chassis
slot
policy
[