Indexer Warning Displays And Troubleshooting - YASKAWA SGD7S-R70A Product Manual

8.2.3

INDEXER Warning Displays and Troubleshooting

INDEXER warning displays and corrections for them are given in the following table.
Alarm
Error No.
Number
E41E A.9F9
A.9F9
E42E
A.9F9
E43E
E44E A.9F9
A.9F9
E46E
A.9F9
E4BE
E4CE A.9F9
Error Name
While writing data to the flash memory, a
failure occurred during one of the following
operation.
Program Table
• While saving a program table by using
Save Failure Error
Fn060
• While initializing a program table by using
Fn063
While writing data to the flash memory, a
failure occurred during one of the following
operation.
ZONE Table Save
• While saving a ZONE table by using
Failure Error
Fn061
• While initializing a ZONE table by using
Fn064
While writing data to the flash memory, a
failure occurred during one of the following
operation.
JOG Speed Table
• While saving a JOG speed table by using
Save Failure Error
Fn061
• While initializing a JOG speed table by
using Fn065
There was a request to start program table
Canceled Pro- operation even though an E19A or E1BA
alarm occurred when the control power
gram Table Error
supply was turned ON.
There was a request to start JOG speed
Canceled JOG
table operation even though an E1FA or
E22A alarm occurred when the control
Speed Table Error
power supply was turned ON.
Travel in the forward direction was
Moving Disabled
requested when P-OT was in effect. (For-
ward movement is disabled when P-OT
Error due to P-OT
(forward overtravel) is in effect.)
Travel in the reverse direction was
Moving Disabled requested when N-OT was in effect.
(Reverse movement is disabled when N-OT
Error due to N-OT
(reverse overtravel) is in effect.)

8.2.3 INDEXER Warning Displays and Troubleshooting

Meaning
Continued on next page.
8.2 Warning Displays
Corrective Action
Repair the hard-
ware.
Repair the hard-
ware.
Repair the hard-
ware.
Remove the
cause of the
alarm.
Remove the
cause of the
alarm.
• When P-OT is
being used,
move to a posi-
tion where the
P-OT is not in
effect.
• When P-OT is
not being used,
disable P-OT in
the parameter.
• When N-OT is
being used,
move to a posi-
tion where the
N-OT is not in
effect.
• When N-OT is
not being used,
disable N-OT in
the parameter.
8
8-47