Troubleshooting Warnings - YASKAWA SGD7S-R70A Product Manual

8.2 Warning Displays

8.2.2 Troubleshooting Warnings

8.2.2

Troubleshooting Warnings

The causes of and corrections for the warnings are given in the following table. Contact your
Yaskawa representative if you cannot solve a problem with the correction given in the table.
Warning Number:
Warning Name
A.900:
Position Deviation
Overflow
A.901:
Position Deviation
Overflow Alarm at
Servo ON
8-42
Possible Cause Confirmation
The Servomotor Check the wiring of the
U, V, and W wiring Servomotor's Main Cir-
is not correct. cuit Cables.
A SERVOPACK Check the SERVO-
gain is too low. PACK gains.
Reduce the reference
The acceleration
acceleration and try
of the position ref-
operating the SERVO-
erence is too high.
PACK.
The excessive
position deviation Check excessive posi-
alarm level (Pn520 tion deviation alarm
× Pn51E/100) is level (Pn520 × Pn51E/
too low for the 100) to see if it is set to
operating condi- an appropriate value.
tions.
A failure occurred
in the SERVO- –
PACK.
The position devi-
ation exceeded
the parameter set-
tings (Pn526 ×
–
Pn528/100) when
the servo was
turned ON.
Correction
Make sure that there are no
faulty connections in the
wiring for the Servomotor
and encoder.
Increase the servo gain,
e.g., by using autotuning
without a host reference.
Reduce the acceleration of
the position reference with
one of the following meth-
ods.
• Reduce the acceleration
rate (ACC) and decelera-
tion rate (DEC) in the pro-
gram table.
• Reduce the settings of
Pn63F (Acceleration Rate)
and Pn640 (Deceleration
Rate).
Optimize the settings of
Pn520 and Pn51E.
Turn the power supply to
the SERVOPACK OFF and
ON again. If an alarm still
occurs, the SERVOPACK
may be faulty. Replace the
SERVOPACK.
Optimize the setting of
Pn528 (Excessive Position
Error Warning Level at
Servo ON).
Continued on next page.
Reference
–
–
–
–
–
–