Siemens SINAMICS G110D Operating Instructions Manual page 70

Commissioning
5.7 Commissioning with the IOP
Note
Optical cables
The cable supplied with the IOP hand-held kit is not suitable for use with the SINAMICS
G110D Inverter. The following cables can be ordered:
• USB optical cable - order number: 6SL3555-0PA00-2AA0
• RS232 optical cable - order number: 3RK1922-2BP00.
The USB optical cable is used to allow a PC to be connected to the Inverter, utilizing the
optical interface on the SINAMICS G110D.
The USB optical cable cannot be used to connect the IOP Hand-held device to the
SINAMICS G110D Inverter.
The RS232 optical cable is used to allow the IOP Hand-held device to be connected to the
Inverter, utilizing the optical interface on the SINAMICS G110D.
Commissioning the Inverter
As previously stated, the IOP is a menu driven operator panel. By choosing the appropriate
menu options the user will be guide through a series of questions, which when answered,
will set the appropriate values for any parameters involving the selected function.
The basic commissioning of the Inverter is performed using the following procedure:
1. From the status screen select the Wizards menu.
2. The wizards menu will display a list of functions
3. Using the wheel, scroll down to the "Basic
4. Press the wheel to confirm selection.
5. The screen will now display the first of a series of
6. Using the wheel select the required answer.
7. Push the wheel to confirm your selection.
8. The screen will then display the next question in
9. Some questions require that a value be set, if the
10. Using the wheel rotate the wheel to increase or
70
that can be selected.
Commissioning" wizard.
questions.
the series.
default value is not acceptable.
decrease the value of the individual digits and
press the wheel to move to the next digit in the
Operating Instructions, 2009-05-15, A5E02385577A AB
SINAMICS G110D