Prerequisites Of Using The Factory Settings; Factory Settings For The Inverter - Siemens SINAMICS G110D Operating Instructions Manual

Commissioning

5.4 Prerequisites of using the factory settings

5.4 Prerequisites of using the factory settings
Prerequisites for using the factory settings
In simple applications, commissioning can be carried out just using the factory settings. This
section explains what prerequisites must be fulfilled for this purpose and how they are
fulfilled.
1. The Inverter and motor must match one another; otherwise you must perform a complete
2. The binary and analog inputs must be connected in accordance with the requirement of
3. You then have to "tell" the Inverter the following,
5.5

Factory settings for the Inverter

Default command and setpoint sources
Inverters used in automation solutions have the appropriate fieldbus interfaces. These
Inverters are preset in the factory so that the appropriate control and status signals can be
exchanged using the fieldbus interface.
Table 5- 1 Command and setpoint sources
Parameter
P0700 = 6
P1000 = 3
54
quick commissioning
(this can be performed using the IOP Hand-held Kit or STARTER).
the application.
– the source of its commands:
- from an operator panel,
- from the digital inputs
- from the fieldbus interface (default setting of the SINAMICS G110D)
You can change this
not appropriate for your application.
– where it gets its speed setpoint (setpoint source)
- from an analog input (analog setpoint)
- as fixed frequency from a digital input (default setting of the SINAMICS G110D)
- from the fieldbus interface
You can change this
setting is not appropriate for your application.
Description
Select the command source
Fieldbus
Select the setpoint source
Fixed frequencies
command source
using parameter P0700 if the factory setting is
frequency setpoint source
Operating Instructions, 2009-05-15, A5E02385577A AB
using parameter P1000 if the factory
SINAMICS G110D