Commissioning
5.1
Typical commissioning scenarios
Alternative commissioning options
The functions of the Inverter are activated and configured using parameters. Parameters can
either be accessed from the operator control/display instrument (Operator Panel) or using
the STARTER software from the PC using the appropriate Inverter interface.
Parameter information and data can also be accessed and modified over the AS-interface.
For further details please see the section "Operation in fieldbus system".
Inverters can also be parameterized by saving the valid Inverter parameter set on an
SD/MMC memory card then transferring it to a different Inverter with the same configuration
and function.
The commissioning scenarios listed below are described in the following sections:
● Commissioning, using the factory settings
● Commissioning with the STARTER software
● Commissioning using the Operator Panel
● Data backup with the SD/MMC memory card
SINAMICS G110D
Operating Instructions, 2009-05-15, A5E02385577A AB
5
49