Siemens SIPART PS2 Operating Instructions Manual page 73

Procedure for installing the EMC filter module
①
②
③
④
Figure 4-17
1. You have performed the steps described in the section "General information on installing
2. Unplug the ribbon cable connector
3. Remove the basic electronics
4. Loosen the screw
5. Insert the connector of the ribbon cable (A) into the slot as shown below.
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
SIPART PS2 with and without HART
Operating Instructions, 02/2016, A5E00074631-AB
EMC filter module terminals
Positioner
Yellow wheel for locking the position detection
Ribbon cable connector of fitted potentiometer,
or ribbon cable connector of EMC filter module
Installation EMC filter module
option modules (Page 54)".
⑤
electronics .
that fix the basic electronics to the pneumatic block.
⑥
in the connection area of the positioner.
Note: There is no space for the ribbon cable (A) in earlier versions of the positioner. Here
you fasten the ribbon cable with the supplied cable tie at the container.
electronics.
④
to the fitted potentiometer from the basic
⑤
from the positioner. To this end, remove the two screws
⑥
⑤
back into the positioner.
④
of the EMC filter module onto the positioner basic
4.7 Installing option modules
⑤
Basic electronics
⑥
Screw
⑦
EMC filter module C73451-A430-D23
loosened in the fourth step.
Installing/mounting
73